9/21/2023 0 Comments Sharex install recorder devices![]() That should be it! Hit your hotkey, capture something (I suggest using this for about 5 to 15-second captures), and it'll produce a small but decent GIF-like video, ready to paste its link anywhere. (This is different from the NVENC version, don't mix them up)įind the word zerolatency in the commands and replace it with grain (this results in better encoding quality)Įxit the settings, open Hotkey settings then set a hotkey for Screen record -> Start/stop screen recording (NOT GIF) with your preferred method such as custom region, active window etc. Slower presets are better quality but use much more CPU. Past Medium is unnecessary, below Very fast is bad quality.ĪFTER all the above is set up, check Use custom commands and locate the part where it says -pix_fmt yuv420p and replace exactly and only that part (preserving the spaces on either side) with the following: Set the Preset anywhere from Very fast to Medium. A lower number better quality, but file sizes will increase) Under the x264 / x265 tab, set CRF to 33 (this usually results in roughly 3000 to 4000kbps total bitrate. To use x264 (CPU encoding) in case you want to, or don't have an NVENC-capable GPU: ![]() (This is different from the x264 version, don't mix them up) Under the NVENC tab, set the Preset to slow (High quality 2 passes) and the Bitrate to 3500 (you can go higher for better quality, but file sizes will increase)ĪFTER all the above is set up, check Use custom commands and locate the part where it says -pix_fmt yuv420p and replace exactly and only that part (preserving the spaces on either side) with the following:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |